Print

[Fenix]

Goedemiddag!  Hi everyone. I am from Ukraine and It is my first topic here. Sorry, maybe you have some place to meet for new members. 
I bought a Trigano Odyssee 2000 and want to make a new lamella bed as on more new models. But I can not understand, how is bed fixing in hinges? All photos in the Internet have no good quality. Maybe someone have an image of these hinges.
Here are images of what I am talking about and what I want to do. (Gas strut I have already) https://i.ytimg.com/vi/PAmevNcuZeE/maxresdefault.jpg   
Thank you every one for a help.

[muis]

Hi, welcom to the forum. I don't know how it's made but i think there are members that do. I would say, the hinges are welded on the frame and the trailer itself.



Wie weet hoe scharnieren van de lattenbodem van de Odyssee zitten

[xray]

The hinges are welded to the bedframe that can be lifted as well (pack&GO) but hope you can see how the hinges are connected to the frame on the bed. I can try and make better pictures as the vouwwagen is in the garage and I can access it if needed.

[Fenix]

Thank you very much. I have no (pack&GO) system and it is really more hard to do same(but it is reaaly cool update), I just want to use bed frame and lift up
 it when tent is set over. So I know that trailers with pack&GO system have another scheme of back hinges, because there became two frames, generall and + bed frame. 

[xray]

Thank you very much. I have no (pack&GO) system and it is really more hard to do same(but it is reaaly cool update), I just want to use bed frame and lift up
 it when tent is set over. So I know that trailers with pack&GO system have another scheme of back hinges, because there became two frames, generall and + bed frame.

I understand not sure if you can see the hinge for lifting the bed when the tent is completely open, but it is in the middle of the bed on teh pictures I've posted. Not sure if that helps?

[Fenix]

Yes, this is gas strut and I see them and also I already have them and have no problem to setup it. Main problem for me was part at begining of bed frame (left side of your images)/
https://i.ytimg.com/vi/QR449-JPkkQ/maxresdefault.jpg  at this image we can this this zone. Hinge in corners of frame.

[Phony]

This is how I constructed a bed in a 2002 Odyssee. Hope this will help.

http://www.imagebam.com/image/4b89da1348893566
http://www.imagebam.com/image/7358011348893644
http://www.imagebam.com/image/87aa9d1348893732

[Fenix]

This is how I constructed a bed in a 2002 Odyssee. Hope this will help.

http://www.imagebam.com/image/4b89da1348893566
http://www.imagebam.com/image/7358011348893644
http://www.imagebam.com/image/87aa9d1348893732

Many thanks!! What size of the bed did you use? And how you did front legs? (what the leading edge rests on)